11
OPERATING INSTRUCTIONS
GB
ruwido m_8 universal remote control
We congratulate you on the purchase of a ruwido universal remote control. Your new remote control replaces the
original remote control of your TV, the remote control of your satellite receiver or DVB-T / cable box (also referred
to as STB in the following) as well as that of your Bluray or DVD player / recorder. Moreover, with your m_8 you
can also operate your audio equipment such as CD player (CD), cassette recorder (TAPE), radio or tuner
(TUNER) or an ampli
fi
er (AMP).
Read all instructions carefully and retain the instructions for reference at a later date. Further information and
additional instructions can be obtained at www.ruwido-consumer.com. If you have any questions you can call us
on the ruwido information line 00800 31133113 at any time.
You can program your remote control using the operating instructions and the associated code and brand list, via
the following methods:
a)
by manual programming, by entering a four digit code from the code list,
b)
by automatic programming, depending on the brand, by entering the three digit code from the brand list
c)
by an automatic searching
d)
or by programming the original remote control codes.
We recommend starting by using the manual programming method (a).
Inserting and replacing the batteries
Your m_8 remote control is powered by two 3-Volt lithium batteries (CR 2032). Insert the batteries in accordance
with the markings on the battery compartment. Please take extra care to ensure correct polarity. Dispose of the
old batteries in accordance with local regulations.
Note
:
Your m_8 has an internal memory to make sure that the programming is retained after changing the batteries.
We recommend that you always use new batteries. Never combine old and new batteries because the
performance of your remote control and the service life of the batteries will be negatively affected.
General information
Your m_8 is
fi
tted with a 5 second protection mechanism. When programming, you must press a button within a
period of 5 seconds, otherwise the remote control reverts back to its regular operating mode.
Note
:
A short double
fl
ash of the signal LED con
fi
rms the input, a long
fl
ash indicates cancellation.
If you enter a code number incorrectly, press any key and wait for a long
fl
ash of the signal LED. You can then
continue entering according to the instructions.
BA m_8 Universal, 135x215 mm CS6.indd 11
BA m_8 Universal, 135x215 mm CS6.indd 11
11.09.2012 16:14:51
11.09.2012 16:14:51
