5
Not recommended to drive or turn too fast, especially on uneven ground, in
order to avoid the risk of falling. Avoid turning or using on tilted or sloped
surfaces as this will affect the driving capabilities of the Speeder and can
greatly reduce your safety.
ASSEMBLY PARTS
ASSEMBLY
Open the box and check that you have all the correct parts according to the parts list.
Check also that you have all parts for the Speeder according to the image on page 4.
1. Mounting the Seat
: Attach the seat to the chassis using the 4 x 21 mm M8 screws and
4 x M8 Lock nuts (C), Allen key and the wrench.
2. Mounting the Handles
: You will need the Allen key and 2 x 13 mm M8 screws with
washers (B). Place the right handle and the left handle onto the correct side and in the
correct position. Each handle should curve out and away from the seat. If the curve
goes into the seat, swap handle sides.
3. Mounting the Front Pedal
: Insert the foot rest tube inside the seat chassis tube. Use
the M8 Star knob to lock in the most comfortable length for your legs when sitting in
the chair. There are several length adjustments that you can choose from, everything
from 70cm to 90cm. Place the Star Knob (D) into the most appropriate hole for your
height and tighten.
4. Attaching the Safety Wheel
: The Hoverkart Speeder comes with an extra safety fea-
ture that prevents you from tipping over during excessive forward motion – the Safety
Wheel. The Safety Wheel attaches to the Chassis underneath the seat by using
2 x 41 mm M8 screws with the lock nuts (A). Place the U-shape bar over the chassis
and insert the 2 screws to tighten the Safety Wheel to the Hoverkart Speeder. Please
see picture on page 4 for reference.
A
A
C
C
C
C
B
B
B
B
D
D
A. 2 x 41mm M8 Screws,
2 x M8 washers
2 x M8 Lock Nuts
B. 2 x 13mm M8 Screws
2 x M8 Washers
C. 4 x 21mm M8 Screws,
4 x M8 Washers,
4 x M8 Lock Nuts
D. 1 x M8 Star Knob
1 x M8 Washer
2 x Allen key
1 x Wrench
