38
ASENNUSOHJE
1. Aseta taitettu lauta tasaiselle paikalle ja avaa se.
2. Kiinnitä evä alla olevan kuvan mukaisesti.
3. Varmista, että venttiilin keskiosa on yläasennossa.
4. Liitä venttiili ja pumppu. Täytä lauta (12–15 psi).
VÄHIMMÄISPAINE ON 12 PSI, JOTTA SUP-LAUTA TOIMII OIKEIN, JA ENIMMÄISPAINE
ON 15 PSI.
Kiristä venttiilin korkki täyttämisen jälkeen. Lopullinen ilmatiiviys saavutetaan vasta,
kun korkki on kiinnitetty.
VINKKI: Jos pumpun mäntä alkaa vinkua, levitä silikonisuihketta männän akseliin.
TUOTTEEN ENIMMÄISPAINE ON 15 PSI.
VAROITUS! ÄLÄ YLITÄ 15 PSI:N ENIMMÄISPAINETTA.
SE VOI VAHINGOITTAA TUOTETTA JA AIHEUTTAA VAMMOJA.
IM_156500080101_Inflatable_standup_paddle_board_v1.indd 38
2021-10-05 13:55
6
ASSEMBLY CONSTRUCTION
1. Place the folded board on a flat surface and unfold.
2. Attach the large fin as shown in the picture below.
3. Be sure that valve core is in the “up and closed” position.
4. Connect the valve and pump. Inflate the pump to high pressure (12–15 psi).
MINIMUM 12 PSI FOR PROPER ISUP OPERATION AND MAXIMUM OF 15 PSI
FOR THIS PRODUCT.
After inflation, tighten the valve cap. Only the valve cap can ensure ultimate air tightness.
TIP: If the pump piston starts to squeak, apply some spray silicone to the piston shaft.
MAXIMUM AIR PRESSURE FOR THIS PRODUCT IS 15 PSI.
WARNING! DO NOT INFLATE BEYOND 15 PSI.
THIS CAN DAMAGE THE PRODUCT AND CAUSE INJURY.
IM_156500080101_Inflatable_standup_paddle_board_v1.indd 6
2021-10-05 13:55
We have three ways to install fins, which can be chosen according to the actual situation.
Your SUP either has a Bravo Fin or Smart Lock Fin System. Please check your fin type and follow
the necessary instructions.
TIP: Before you begin please ensure the fin box slot is clean and free of sand and grit.
CENTER FIN
Slide the fin into the
fin box.Make sure fin
and card slot of fin
box in the same
position.
Place the bolt in the
chute and rotate tightly
to ensure that the fin
do not fall off.
Slide the fin into the
fin box.Make sure fin
and card slot of fin
box in the same
position.
Insert the gasket into
the slot to ensure that
the gasket can catch
the fin
.
Unscrew the plate from the screw (Figure 1) and place into the fin slot via the gap (Figure 2).
TIP: Use the screw to slide the plate into place along the slot.Insert the fin into the fin box slot
via the central gap, slide the fin to the back and firmly push down the other end (Figure 3).Line
up the screw with the screw plate and tighten until fully secure (Figure 4).
Figure 1.
Figure 1.
Figure 2.
Figure 2.
Figure 1.
Figure 2.
Figure 3.
Figure 4.
Screw Fin
Slide Fin
US Fin
6
FIN TYPE:
Paddle to Adventure
