WARNING
Place the switch in off position before making any adjustments or
changing pouches/colors.
Operating Instructions
1.
Check integrity of device and pouch to ensure that there are no leaks,
breaks, cracks, etc.
2.
Remove cap from SpraySmart
®
device.
3.
Massage pouch for 10 seconds and shake for 20 seconds to ensure that
paint is mixed.
4.
Insert pouch into the bottom of the cap until nozzle extends through
cap opening.
5.
Hold inner ring of cap and turn counter clockwise to lock cap to pouch.
6.
Insert pouch into device and secure top assembly by screwing down
outer ring onto the body of the device until tight.
7.
Press the power button on the bottom of the device to start the compression
of the paint pouch.
–
The green “Ready” light will begin blinking.
–
The device can be placed into wand as needed.
8.
When green “Ready” light turns solid green the device is ready to spray paint,
even though compressor may continue to run.
9.
The device will automatically pressurize and run the compressor as needed to
maintain pressure.
10.
To change pouch or storage of device:
–
Press the device power button to turn off.
–
Release the pressure in the device by pressing the pressure relief valve
located on the cap, the release of air from the device is audible.
–
Unscrew the cap by turning it counter clockwise.
–
Pull cap and pouch out of the device.
–
Hold pouch and turn cap counter clockwise to release the pouch
from the device cap.
–
The pouch can then be stored or disposed of.
11.
Charge device when battery indicator shows 1 bar. Battery indicator
will flash when battery is drained.
12.
Once battery is charged, unplug the charger and remove the device.
Using Chargers:
The lithium-ion battery that powers the SpraySmart
®
device is housed inside of the
device itself. To charge the device, simply plug in the wall mount or USB and then
push the charger’s male connector into the female receptacle within the base of the
SpraySmart
®
device. The charger is working when the battery symbol on the bottom
of the device begins to blink showing the battery’s current charge level. When the
battery is fully charged, the charger should be unplugged and the device should be
removed from the charger. Always unplug chargers when they are not in use.
The charger was designed to charge the battery only when the battery is between
0° F and 105°F.
If battery does not charge properly:
1.
Check for voltage at outlet by plugging in some other electrical device to
ensure that it works.
2.
Check to see if outlet is connected to a light switch which turns power “off”
when lights are turned off.
3.
Check charger to ensure that there is no debris or damage to the
male connector.
4.
Call our customer service number:
1-800-553-8444
RUST-OLEUM SPRAYSMART
®
USAGE & CARE INSTRUCTIONS
© 2014 Rust-Oleum Corporation
