INSTALLING DURING NEW CONSTRUCTION
Needless to say, installing In-Wall speakers when a house is being built is
far easier than doing it later. Russound offers a Speaker Rough-In
Brackets for round speakers (Model SB-1.5). The bracket is designed to
provide the drywall installers the cut-out for the In-Walls. Each kit
comes with two brackets, (one is required per speaker). The brackets are
nailed/screwed onto the wall studs. Once the house/room is completed,
you can install the speaker (more on this below).
During new installation, keep the following tips in mind:
• Use a small level to verify that the mounting frame is straight.
• The flat brackets and nails which attach the speakers are thin enough
that they won’t interfere with wallboard added later.
• If possible, run speaker wires after AC wiring is in place to avoid
induced hum caused by close parallel proximity.
• Secure speaker wires in place along the run with insulated staples
only and be careful not to pierce the insulation. Allow a bit of slack
for expansion of building materials.
• The actual speakers should not be installed until the wall board is in
place. In the meantime, leave several feet of wire coiled up and
secured to the back side of the mounting frame.
• When it comes time to put up the dry wall, make sure the speaker
cut-out hole doesn’t extend farther than 1/4” from the sides of the
mounting frame.
• After the wallboard is put up, install the speakers as detailed on page
9 of this manual.
Due to our continual efforts to improve product quality as new technol-
ogy and techniques become available, Russound/FMP, Inc. reserves the
right to revise speaker systems specifications without notice.
WARRANTY
All Russound Speaker products are fully guaranteed against all defects in
materials and workmanship for five years from date of purchase. Proof
of Receipt must accompany all claims. During the warranty period
Russound will replace any defective part and correct any defect in work-
manship without charge for either parts or labor. For this warranty to
apply, the unit must be installed and used according to its written
instructions. If necessary, repairs must be performed by Russound. The
unit must be returned to Russound at the owner’s expense and with
prior written permission. Accidental damage and shipping damage are
not considered defects, nor is damage resulting from abuse or from ser-
vicing performed by an agency or person not specifically authorized in
writing by Russound. Damage to or destruction of components due to
application of excessive power voids the warranty on those parts. In
these cases repairs will be made on the basis of the retail value of the
parts and labor. To return for repairs, the unit must be shipped to
Russound at the owner’s expense, along with a note explaining the
nature of service required. Be sure to pack in a corrugated container
with at least 3 inches of resilient material to protect the unit from dam-
age in transit.
This Warranty Does Not Cover:
• Damage caused by abuse, accident, misuse, negligence, or improper
operation (installation).
• Products that have been altered or modified.
• Any product whose identifying number or decal, serial #, etc. has
been altered, defaced or removed.
• Normal wear and maintenance.
9
Figure 7
Summary of Contents for SP503.1
Page 11: ...NOTES 11 ...
