4
Russound Architectural Series of In-Wall Loudspeakers
Listening Test
It’s a good idea to test everything at this point.
1.
Turn on your stereo system or music source. Make sure that the
volume control is turned down and that the balance control is set
to center.
2.
Gently turn up the volume. You should hear music coming out of your
new Russound Speakers! (If you don’t, refer to the troubleshooting
guide.)
3.
Now rotate the stereo’s balance control all the way to the left. Sound
should only come out of your left speaker. If it comes out of the right
speaker, skip to Step 5.
4.
Rotate the balance control all the way to the right. Sound should only
come out of the right speaker.
5.
If sound comes from the right speaker when the stereo’s balance
control is turned to the left, you’ll need to change the connections
on the back of the amplifier/receiver. Note: Turn off the amplifier.
Swap the wires attached to the left and right speaker terminals before
turning the amplifier back on. Make sure to keep the (+) and (-) the
same for left and right speakers.
Installation
1. Connect the speaker wire to the speaker terminals:
•
Leave about 2’ (60 cm) of wire extending through the ceiling or wall
cutout.
•
Pull the conductors apart so the last two inches are separated and
remove 1/2” (13 mm) of insulation from the end of each conductor.
•
Twist the strands in each conductor into tight spirals.
•
Attach the speaker wires to the red and black speaker terminals.
Connect the Positive (+) conductor to the Red terminal and the
Negative (-) conductor to the Black terminal. Make sure that no stray
strands of wire are touching the other conductor or terminal.
Center the speaker in the cut out. The IW-620 (as well as the IC-20, IC-820 and
IC-630 models) features the *patented SwiftLock™ by Swarm design. For the
IW-620, position the speaker in the opening and hold it in place, then press
each of the four SwiftLock™ installation buttons. You will hear a resounding
“click” letting you know the speaker is securely mounted in place.
3. Attach the magnetic grille.
INSTALLATION AND TECHNICAL SPECIFICATIONS
Removing a Swiftlock
TM
Speaker
Removing a Swiftlock
TM
speaker is quick and easy.
Simply insert a #2 Phillips Screwdriver into the
screwhead, push the screw in and turn the screw a 1/2-
turn counter-clockwise to lock it into place.
*US Patent 10,024,493
Speaker
Press each of the four
Swiftlock
TM
installation
buttons. (One for each
of the four dogs).
Cutout
Speaker Cable
Install Speaker
Repeat for the other Swiftlock
TM
mounting dogs
Insertion of speaker wire on back of speaker baffle
(+)
(+)
(-)
(-)
