Russound Architectural Series of In-Ceiling and In-Wall Loudspeakers
6
2. Center the speaker in the cutout. For
the IC-610 and IC610T models: Rotate the
frame as needed before tightening the
mounting dog screws. Tighten the screws
equally until the clamps secure the frame.
Do not over-tighten.
IC-620, IC-820, IC-630 and IW-620 models
- These models feature the patented
Swiftlock™ by Swarm attachment design.
For these models position the speaker in
the opening, rotate them to the desired
position and hold them in place - and
then press each of the three Swiftlock™
installation buttons. You will hear a
resounding “click” letting you know the
speaker is securely mounted in place.
3. Attach the magnetic grille.
Installation
1. Connect the speaker wire to the speaker
terminals:
•
Leave about 2’ (60 cm) of wire
extending through the ceiling or wall
cutout.
•
Pull the conductors apart so the last
two inches are separated and
remove 1/2” (13 mm) of insulation
from the end of each conductor.
•
Twist the strands in each conductor
into tight spirals.
•
Attach the speaker wires to the red
and black speaker terminals. Connect
the Positive (+) conductor to the
Red terminal and the Negative (-)
conductor to the Black terminal. Make
sure that no stray strands of wire
are touching the other conductor or
terminal.
•
NOTE: Single point speakers have four
terminals; Right(+), (-) and Left(+),
(-). Run an extra pair of wires and
observe proper polarity when making
connections.
INSTALLATION
Removing a Swiftlock
TM
Speaker
Removing a Swiftlock
TM
speaker is quick and easy.
Simply insert a #2 Philpps Screwdriver into the
screwhead, push the screw in and turn the screw a 1/2-
turn counter-clockwise to lock it into place.
Speaker
Press each of the three
Swiftlock
TM
installation
buttons. (One for each
of the three dogs).
Cutout
Speaker
Cable
Install Speaker
Repeat for the other two Swiftlock
TM
mounting dogs
Insertion of speaker wire on back of speaker baffle
(+)
(+)
(-)
(-)
