7
SPECIFICATIONS
Audio power output: Continuous 50W @ 8 ohms,
75W @ 4 ohms.
Frequency response: 20HZ to 20KHZ -0.3dB.
Total harmonic distortion: 0.05% 8 Ohm, .075% 4 Ohm
Input sensitivity: 400mV line
Input impedance: 22k Line Input
Signal to noise ratio: 85dB
Auto off delay time: 2 to 10 minutes
Primary fuse: T3.15/250V
Power requirements: Factory set for 110 VAC 60Hz or 240
VAC 50Hz. IEC 320 type connector with 2 terminal detachable
power cord. For 240VAC operation, use a power cord (not
supplied) rated for 240VAC 4 amps or higher.
Weight: 32 lbs.
Dimensions: 19" W x 13.5"D x 5.25"H
WARRANTY
The Russound DPA-4.8 is fully guaranteed for two (2) years from the date of pur-
chase against all defects in materials and workmanship. During this period Russound
will replace any defective parts and correct any defect in workmanship without
charge for either parts or labor. For this warranty to apply, the unit must be installed
and used according to its written instructions. If service is necessary, it must be per-
formed by Russound. The unit must be returned to Russound at the owners expense
and with prior written permission. Accidental damage and shipping damage are not
considered defects under the terms of the warranty. Russound assumes no responsi-
bility for defects resulting from abuse or servicing performed by an agency or per-
son not specifically authorized in writing by Russound. Damage to or destruction of
components due to improper use voids the warranty. In these cases the repair will
be made at the owners expense. To return for repairs, the unit must be shipped to
Russound at the owners expense, along with a note explaining the nature of the
service required. Be sure to pack in a corrugated container with at least 3 inches of
resilient material to protect the unit from damage in transit.
