9
Russound Acclaim OutBack Loudspeaker Installation Manual
cOnnect tO AmplIfIer / trOuBleShOOtIng
Connecting the amplifier
Make sure the amplifier is turned off.
1.
Strip 1 to 2 inches (2.5 to 5 cm) off the end of each cable’s outer jacket.
2.
Then strip just enough insulation off each wire to allow inserting the wires
fully into the amplifier’s speaker terminals.
Twist the wire strands together so there are no strands separated from the
3.
bundle.
Connect the wires to the speaker terminals, being sure to observe proper
4.
polarity.
Check to make sure there are no stray strands of wire outside the terminals.
5.
If there are, remove the wire, twist the strands together, and reconnect the
wire to the terminal.
Speaker care
These sealed construction speakers are made of durable materials that need
very little care. Occasionally wipe them with a soft, damp cloth. Do not use any
harsh detergents, chemical solvents, or abrasive materials on your speakers,
and do not spray water or other liquids into the grilles.
Troubleshooting Guide
Before returning your Russound speakers for service, try these simple
remedies first.
No sound from either speaker:
Incorrect source selected on receiver or preamplifier.
•
Mute button pressed on receiver.
•
Wrong speaker output selected; many receivers have an "A" and "B" speaker
•
switch. Make sure it is in the correct position.
In-wall volume control not turned up or wired incorrectly.
•
If using a speaker selector, room/station not turned on or improperly
•
connected.
No sound from one speaker:
Unsecured connection at either the speaker or amplifier - double-check all
•
connections.
Balance control turned all the way left or right - return it to center.
•
Bad connecting cable between sound source and amplifier - try a new
•
cable.
Check for stray wire strands crossing the speaker terminals.
•
Defective speaker - contact your Russound dealer or call Russound Tech
•
Support at 603.659.5170.
Muffled sound from single point stereo speaker:
Check polarity of speaker connections. One channel may be reversed.
•
Any other problems not listed, discuss with your dealer or call Russound.
