6
39 Check that there’s water in the reservoir.
40 Set the temperature control to
max
, set the steam control to
S
.
41 Hold the iron close to (but not touching) the fabric.
42 Press the
#
button (it’s the shot of steam function used vertically).
43 It may need 2 or 3 presses to pump water through the system.
44 Leave 4 seconds between shots, to let the temperature build up.
C
AFTER USE (#7)
45 Turn the temperature control to
•
, move the steam control to
S
.
46 Unplug the iron.
47 Lift the top of the water inlet cover to open it.
48 Turn the iron upside down over a sink, and drain the reservoir.
49 Sit the iron on its heel till it’s cold.
50 Close the water inlet cover, and wipe off any moisture.
54 Store the iron on its heel, to avoid corrosion.
C
SELF CLEAN (#8)
55 To reduce scale build-up, use the self clean function at least
monthly in normal water areas, more often in hard water areas.
56 You’ll need a basin or a large bowl to catch the water coming out
of the soleplate.
57 Fill the reservoir to the
max
mark.
58 Set the temperature control to
max
, set the steam control to
S
.
59 Sit the iron on its heel.
60 Plug it in, and wait till the thermostat light goes out.
61 Hold the iron over the basin or bowl, with the soleplate down.
62 Press the
C
button, hold it in, and gently move the iron to and
fro, over the basin or bowl.
caution
keep clear of the escaping water and steam
63 Water and steam will wash scale and dust through the soleplate,
and into the sink.
64 When the reservoir is empty, release the
C
button.
65 Unplug the iron, and sit it on its heel to cool.
66 Wipe off any moisture.
67 Store the iron on its heel, to avoid corrosion.
Summary of Contents for steam glide
Page 2: ...2...
