failure cannot be accepted if this instruction has been ignored.
•
This product is intended for household use only. Industrial or commercial
use invalidates the warranty.
PARTS NAME & LOCATION
ASSEMBLY INSTRUCTIONS
Your Russell Hobbs Fan has been boxed unassembled to minimize packaging
waste. Each part fits together easily and can be removed for cleaning, and storage.
1. Take the fan out of the box and remove any protective wrappings.
2. Place all the parts on the floor.
3. Remove the four position screws on the base, align the base with the four
holes on the holding plate, insert the four position screws and tighten.
4. Remove the four position screws on the motor and align the rear guard
with the four holes on the motor (handle facing top of the fan) insert the
four position screws and tighten.
5. Loosen the set screw on the blade; slide the blade on to the shaft of the
motor. Tighten the set screw on to the flat side of the shaft to secure the
blade ensuring the blade does not damage the guards.
6. Assemble the front guard to the rear guard. Tighten the connecting screw
and nut; thereafter secure the retaining clips.
OPERATING INSTRUCTIONS
1
．
The on/off switch is incorporated in the speed control switch on the head
of the fan.
2
．
Your Russell Hobbs fan control has three speed settings. The various
speed settings assist in regulating the airflow from the fan:
0 The fan is switched off.
1 The fan operates at the lowest speed.
2 The fan operates at the medium speed.
3 The fan operates at the highest speed.
3
．
The fan can operate in oscillation or static mode;
4
．
To make the fan head oscillate, push down the Oscillation Knob.
5
．
To stop the fan head from oscillating pull the Oscillation Knob up.
6
．
The head of the fan can be adjusted up or down - to do this unplug unit,
loosen the adjusting knob; adjust the fan to the desired angle. To secure
tighten the Adjusting Knob.