RHMPF1611CH
Revision 2.1
PARTS
ASSEMBLY
SPEED SETTINGS & OSCILLATION
Select a speed between 1-3. Press the switch on the rear of the fan to engage
the oscillation feature.
1.
Unscrew the Base Securing Screw [18] and remove
the Washer [17] form the Extension Tube [6]
2.
Place the Base Weight [16] under the Base Plate
[15] and apply the Washer [17], before screwing in
the Securing Screw [18] through the middle into the
Extension Pole [6]
3.
Loosen the Height Dial [not shown] and extend the
tube. Attach Extension Pole [6] onto Motor
Housing [9] and thread Fixing Screw [20] into
square hole, and thread the Fixing Screw 1 [19] into
top hole on opposite side.
4.
Attach Tilt Adjustment Dial [7] onto Fixing Screw 2
[20].
1.
Front Grille
2.
Grille Securing Screw
3.
Fan Blade
4.
Rear Grille
5.
Grille Securing Nut
6.
Extension Pole
7.
Tilt Adjustment Dial
8.
Tilt Adjustment Knob
9.
Motor Housing
10.
On/Off/Speed Selection
11.
Oscillation Button
12.
Fan Fixing Point
13.
Fan Blade Screw
14.
Grille Retaining Clips
15.
Base Plate
16.
Base Weight
17.
Washer
18.
Base Securing Screw
19.
Fixing Screw 1
20.
Fixing Screw 2
5.
Attach Tilt Adjustment Knob [8] and tighten to
hold the motor unit in place.
6.
Remove any protective sleeves from the
appliance, & 4 Securing Screws [not shown]
from Motor Housing [9]
7.
Place Rear Grille [4] on Motor Housing [9] &
attach with 4 Securing Screws.
8.
Attach Fan Blade [3] onto Fixing Point [12] and
secure with screw [13] against flat part of the
motor shaft.
9.
Clip Front Grille [3] onto Rear Grille [4] using
attached clips, and screw in using Grille
Securing Screw & Nut [2 & 5]