19
The c
apsule can’t or hasn’t
dropped down into the used
capsule container/ bin.
The used capsule container/
bin are full.
The capsule is deformed.
Empty the used capsule
container/ bin.
Push the capsule down or
close the handle and open it
once again.
There is steam when the
operating handle is opened.
The handle may have been
opened too quickly once
brewing finished.
Leave the appliance for a few
seconds to let the residual
pressure and existing pressure
to escape.
There is water on the table.
The water tank may be
leaking.
The drip tray is full of water.
Once brewing had finished,
one could have opened the
brewing chamber without
the drip tray set in place.
Check if the valve on the
water reservoir is stuck.
Empty the drip tray.
Make sure that the drip tray
set correctly in its in place.
The capsule drops down
directly into the used
capsule container before I
have started the loading
and brewing process.
The capsule is deformed.
Try it again with a slight
different angle.
Use a new capsule.
There are occasional drops
driping out of the dispenser
spout.
The heating system remains
warm.
Occasional drops are normal, it
is not a defect.
Coffee comes out in drips/
coffee goes into the used
capsule container/ bin.
The ground coffee in the
capsule is ground too fine to let
water pass through sufficiently.
Change to a new capsule.
Use another brand of
compatible capsule.
