13
Water Drainage
This machine has an auto-water-evaporating system. Condensed water is
used to cool down the condenser, which not only improves cooling efficiency,
but also saves energy.
●
If inner water tank is full, “
” will flash on the screen . The machine enters into standby mode;
buzzer sounds, compressor stops and all keys are deactivated invalid till machine returns to normal.
●
Referring to the sketch below, unscrew the drain knob 1 at the back of the unit towards the bottom.
Place a container near the outlet into which the water can drain.
Pull out the rubber plug to empty out
water. Power off the machine and restart it. The machine will run normally.
Special caution for heat pump function!
When in heating mode, if you wish to operate the unit without the need to empty the water tank,
please connect a water-drainage-pipe to remove the water out continuously.
1.
Remove the drain knob.
2.
Remove the rubber plug and retain for future use
3.
Fix the drain connector into the drain knob.
4.
Fix the drain knob to the water outlet of the unit.
5.
Connect the drain tube (Inside Diameter:10mm) to the water outlet as shown and locate the other end
into a drain below the drain outlet..
Note:
The water-container must be at or lower the outlet level