Russell Hobbs RH612WM1 Series, Instruction Manual

Page: 10 / 44

1. Connect new water inlet hoses to a ¾˝, threaded tap. Connect the
white capped end of the water inlet hose to the white water inlet
valve on the rear side of the machine
2. Hand tighten the connections. If in any doubt, consult a qualified
plumber. Water flow with pressure of 0.1-1 Mpa will allow your
machine to operate at optimum efficiency (pressure of 0.1 Mpa means
that more than 8 litres of water per minute will flow through a fully
opened tap).
3. Never attempt to extend the water outlet hose by adding extra parts.
4. If the outlet hose is too long, do not force it back into the washer.
This will cause abnormal noise and damage to the product.
5. Once you have made all of the connections, carefully turn the
water supply on and check for leaks.
6. Ensure that the new water inlet hoses are not trapped, kinked,
twisted, folded or crushed.
1 2 3 4
10
Installation