Russell Hobbs Precision Heat, Instructions Manual

Page: 4 / 8

4
switch on
12 Move the steam control to
S
(#3).
13 Sit the iron on its heel.
14 Put the plug into the power socket (switch the socket on, if it’s switchable).
15 The tip will glow or flash.
16 It’ll flash while heating/cooling, then glow steadily when it’s at the set temperature.
17 The colours are:
orange cold
blue
•
green
• •
pink
• • •
red max
18 Turn the temperature control to bring the
)
mark round to the setting you want (#3).
19 The colour of the tip will change to match the colour of your chosen setting.
20 The tip will flash till it reaches the set temperature, then it’ll glow steadily.
21 Wait till the tip glows steadily, then start ironing.
reducing temperature
22 This takes a bit longer, as the iron has to lose the heat it has built up, so be patient.
23 Wait till the tip colour matches the new setting (
•
blue,
••
green,
•••
pink, max red).
24 Better still – save time by organising your ironing so that you don’t need to reduce
the temperature.
steam ironing
25 When steam ironing, you must set the temperature control at
#
or higher.
26 If you don’t, you’ll get water on your clothes, not steam.
27 Move the steam control to the setting you want,
S
= no steam,
#
= high steam (#3).
28 Wait till the tip changes to the correct colour, then start ironing.
spray
,
Water spotting affects some fabrics. Test this out on a hidden part of the fabric.
29 This works with dry or steam ironing, as long as there’s water in the reservoir.
30 Check that there’s water in the reservoir.
31 Lift the iron off the fabric.
32 Aim the spray nozzle at the fabric.
33 Press the
*
button – you may have to press it 2 or 3
times to pump water through the system.