Russell Hobbs 22280-56, Instructions Manual, Page: 3 / 68

3
Read the instructions, keep them safe, pass them on if you pass the appliance on. Remove all
packaging before use.
IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
This appliance can be used by persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge
if they have been supervised/instructed and understand the
hazards involved.
Children must not use or play with the appliance.
Keep the appliance and cable out of reach of children.
c
Misuse of the appliance may cause injury.
Unplug the appliance before assembly, disassembly, or cleaning.
Don’t leave the appliance unattended while plugged in.
If the cable is damaged, it must be replaced by the manufacturer, its
service agent, or someone similarly qualified, to avoid hazard.
l
Don’t put the motor unit in liquid.
• Don’t use fingers or cutlery to push food down the tube – only the pusher.
• Don’t use the appliance for any purpose other than those described in these instructions.
• Don’t operate the appliance if it’s damaged or malfunctions.
• Don’t run the motor continuously for more than 2 minutes, it may overheat. After 2 minutes
switch off for at least 2 minutes, to recover.
HOUSEHOLD USE ONLY
DIAGRAMS
1. Tab
2. Slots
3. Cutters
4. Slicer
5. Coarse grater
6. Fine grater
7. Ring nut
8. Bayonet fitting
9. Cutter mount
10. Body
11. Tube
12. Guides
13. Pusher
14. Cap
15. Switch
16. Motor unit
`
dishwasher safe
ASSEMBLY
1. Switch the appliance off ( O ) and unplug it.
2. Choose the pair of cutters you need – slicer, coarse grater, fine grater.
3. Stand the cutter mount upright on the work surface. Don’t try to fit the cutters to the cutter
mount while holding it in the operating position or you might cut yourself.
4. Fit the tabs on the wide end of the cutter into the slots in the wide end of the cutter mount.
5. Press the tab on the narrow end of the cutter into the space in the narrow end of the cutter
mount.
6. Turn the cutter mount, then fit the second cutter.
7. Slide the cutter mount into the body.
8. Turn the ring nut 45° clockwise.
9. Push it on to the front of the body.
10. Turn it 45° anti-clockwise, to lock it in place.
ins
tru
cti
ons