4
switching on
10 Put the kettle on the stand – take care not to spill.
11 Plug the stand into a power socket (switch the socket on, if it’s switchable).
12 Press and release the
2
button – this switches on the display and the element.
13 The display will show
99
(flashing), and the kettle will start to heat up.
boil
14 If you want to boil the water, leave it at
99
.
15 When the water boils, the element will switch off, and the display will stop flashing.
16 After about a minute, the display will switch off.
variable temperature
17 If you want to heat the water to a different temperature, use the
-
and
+
buttons to
change the display from
99
(boil) to the temperature you want.
18 The temperatures available are: 99 (boil), 95, 90, 85, 80, 75, 70, 65, and 60 (that’s °C).
19 The display will flash while the water is heating, then stop flashing to show that it
has reached the set temperature.
20 After about a minute, the display will switch off.
changing temperature
21 When the kettle has reached the set temperature, you can’t reduce the temperature
setting on the display till the water has cooled down.
22 Normally, this wouldn’t matter, because you would use the water at the temperature
you set, then refill the kettle.
23 If you get the temperature wrong, and want to change it:
either
pour the hot water away, and refill with cold water
or
wait till the kettle cools down (it’ll cool a bit faster if you open the lid)
keep warm
24 If you want the kettle to keep the water at the set temperature, press and release the
9
button.
,
This function only works at the 90, 85, 80, 75, 70, 65, and 60 settings.
25 A dot will appear on the bottom right of the display to show that the keep warm
function is operating.
26 When the keep warm function is operating, the display won’t switch off after a
minute, it’ll remain lit.
27 The element will switch on intermittently, to keep the water hot.
28 When it’s heating, the display will flash. The flashing will stop when the water again
reaches the set temperature.
29 To cancel the keep warm function, press and release the
9
button again – the dot
will disappear.
caution
keep an eye on the water level – don’t let the level get below 2 cups
switching off
30 To switch off manually, press and release
2
.
31 This will switch off the element and the display, and put the kettle into standby
mode.
32 To save electricity, unplug the stand.
