7
46 To replace the HEPA filter, fit the top tab into its slot, push the filter against the back
of the bin, then lower it, to engage the bottom tabs in their slots.
mesh filter
47 This protects the HEPA filter from big bits.
48 Turn the bin upside down and open it.
49 Turn the mesh filter about a centimetre anti-clockwise to release it, and lift it out.
50 Again, if it looks a bit mucky, tap it over the newspaper, to dislodge the dirt. if it’s
really dirty, soak it in warm soapy water for a few minutes, rinse under a running tap,
to remove all trace of soap, then let it air dry – don’t refit till it’s completely dry.
51 To refit it, replace it in the bin, and turn it about a centimetre clockwise to lock it in
place.
52 Close the bin bottom and lock it with the latch.
53 Lower the bin into the cleaner.
54 Lower the bin handle – this’ll lock the bin into the cleaner.
outlet filter
55 Push the lock down, then lift the cover off the cleaner.
56 Pull the outlet filter out of the cover.
57 If the filter looks a bit mucky, tap it over the newspaper, to dislodge the dirt.
58 If its very dirty, soak it in warm soapy water, swill it out under a running tap, to
remove all trace of soap, then let it air dry, till it’s completely dry, before refitting.
59 Put the filter into the rear of the holder – the white side of the filter should be
towards the cleaner.
60 Fit the holder and filter into the rear of the cleaner.
61 Fit the lugs in the bottom of the cover into the slot in the cleaner, and push the top
of the cover into the cleaner, till it clicks into place.
cleaning
Switch the cleaner off and unplug it before cleaning.
Don’t put any part of the cleaner in a dishwasher.
Don’t use harsh or abrasive cleaning agents or solvents.
timing
• Clean the cleaner frequently. Basically, the better you look after it, the longer it’ll last.
Keep an eye on it as you use it, and examine the filters when you empty the bin. If
anything needs cleaning, do it there and then, don’t put it off, in case you forget.
• Wipe external surfaces with a damp cloth. A dab of washing-up liquid will remove
stubborn stains, but clean it off afterwards, or it may stain.
• Wipe the tools with a damp cloth, or hand wash in warm soapy water. Rinse to
remove any trace of soap, and air dry before using.
• Wipe the extendable tube and hose with a damp cloth. Again, you can use a dab of
washing-up liquid to remove any stubborn marks. Remove all trace of the washing-
up liquid, and check they’re dry before refitting. Don’t put them in water, you’ll
damage them.
• Hand wash the bin in warm soapy water. Use a washing-up cloth or a gentle sponge,
don’t use a hard sponge or scouring pad. Rinse to remove all trace of soap and air
dry. Don’t replace it till it’s fully dry.
Summary of Contents for 13759
Page 2: ...2...