EN
33
Bluish chain
links
○ Lack of chain lubrication
○ Check the chainsaw
lubrication system and replace
the chain
Guide bar with
pitting
○ The chain is not
sharpened properly and the
user has exerted pressure
on the chainsaw under load
○ Chain bar and chain
replacement
The engine does
not rev
○ The fuel filter is clogged
with impurities
○ Replace the fuel filter and
check the fuel system
The chain does
not spin when
the engine is
accelerating
○ The chain brake is locked
○ Unlock the chain brake
Heavy smoke
from the engine
○ Too much oil in the
mixture
○ Empty the tank and redo the
mixture according to the
operating instructions
The chain has
no lubrication
○ Lack of chain lubricating
oil in the tank
○ Clogged oil filter
○ Damaged oil pump
○ Refill the chain lubrication oil
tank
○ Replace the oil filter
○ Go to an authorized RURIS
service station
Bar guide
clogged with
sawdust
○ The guide bar feed ramp
is clogged with sawdust
○ Clean the bar guide from
sawdust
Shocks during
operation
○ The front splitting spur of
the tooth is below the
section height of the tooth
○ Correct by sharpening the
chain
The chain does
not cut
○ The chain is not
sharpened
○ Sharpen the chain
13. STORING THE MACHINE
If you do not use the chainsaw for a long time (more than a week), proceed as follows:
•
Clean the chainsaw.
•
Drain the fuel from the tank.
•
Start the chainsaw and let it run until the fuel in the carburettor is consumed
and the chainsaw stops. This operation is necessary to prevent petrol
evaporating from the mixture, which can cause the carburettor orifice to
become clogged by deposits of remaining oil.
•
Store it in a dry place, out of the reach of children.
