21
Make sure that the Ruptor R1 charger is at the best condition. Check the connector is free of dust, if so,
clean and ensure dry.
Always use the original charger supplied and connect it correctly to the device (via the charging port)
and power outlets. It is important to always use the charger shipped with the Ruptor R1. Once the pro-
duct is loaded, disconnect charger from Ruptor
The adapter must be immediately disconnected from the network to stop charging. Battery life will be
aff ected by the battery charging time, never exceed, and will extend the battery life.. Do not charge the
product when the adapter light turns green or overcharges the battery for more than 5 hours.
TIPS TO REMEMBER WHEN LOADING
Mount preferably away from fl ammable products.
Monitor the charging cycle (not exceeding the recommended value).
Use only the original charger.
For the charging process, the skateboard must be turned off and the accessories are not attached
because the battery will overheat if any of the sensors cannot be activated.
When the charger LED changes from red to green, the smart gyroscope is charged.
No live ignition or work
Remove the rubber cover and insert the charging cable. After loading, place the rubber cover in
position.
Move the handlebar front and rear to check that it
Raise the control lever to secure the folding handle,
while fi rmly fi xing the folding lever.
Turn the handlebar to raise it to the
desired position. Once raised, tighten
the handle.
CHARGE YOUR SCOOTER