Main Support no.: +370 5 2045030
Polish Support no.: +48 22 2092532
Ukrainian Support no.: +380 947 107319
10
www.ruptela.com
4
Device preparation (regular housing)
In order for the device to work you have to
configure it and insert a SIM card. To do so, you
have to open the device enclosure and perform the
actions described below.
4.1
Opening/Closing the device
Use a screwdriver or a similar tool to open up the
plastic housing of the device. It is recommended to
use a flat-head type screwdriver (
see the picture on
the right
). Inappropriate tools might cause
permanent damage to the device.
To correctly assemble the device, you must know
the exact positions of all the plastic pins used to hold
the PCB in place (
see the picture on the right
).
These positions are listed in the table below:
Proper assembly sequence:
1.
Make sure that the PCB is facing upwards. Only then it can be mounted in its plastic housing.
2.
The PCB goes under the intermediary plastic pin (1).
3.
It is then mounted on the stabilizer (2).
4.
The PCB must be correctly placed on the PCB support pin (3).
When the assembly sequence described above is completed, push the other side of the PCB down into a
stable position.
The plastic lid of the device can be mounted only
when all of the PCB pins are holding the PCB in a
stable position (
see the above picture
).
To correctly seal the plastic housing of the device,
start by placing the plastic lid at either side of the
device (
see the picture on the right
). Then push the
remaining side down until the housing is fully
closed.
No.
Name
1
The intermediary PCB pin
2
The PCB stabilizer pin
3
The PCB support pin
