PRODUCT SAFETY GUIDELINES
BEFORE STARTING
Please carefully read all instructions before using RUNHOOD Portable Power Station.
WARNING
Keep RUNHOOD Power Station dry and do not expose to high heat or water.
DO NOT disassemble or remove the protective covering.
DO NOT puncture or incinerate the product or the accessories.
Recycle and dispose of RUNHOOD Power Station in accordance with the local regulations.
Pay attention to safety when handling the RUNHOOD Power Station.
Children and those with impairments should operate the device with assistance.
Improper use may result in fire, property damage or personal injury.
Only use the product according to the safety guidelines.
PRODUCT USE
DO NOT expose RUNHOOD Power Station to liquid or to rain, snow, hail, etc.
DO NOT pierce the product. Doing so may cause leakage or fire hazard.
DO NOT use the product if it is involved in a crash or a heavy impact.
DO NOT put the device inside a microwave oven or a pressurized container.
1
DO NOT submerge the RUNHOOD Power Station in water. Exposure to water may cause chemical
decomposition of the battery resulting in combustion. Please contact our service department for
assistance on such occasions.
Only use RUNHOOD batteries with this product. RUNHOOD takes no responsibility for any damage caused by
non- RUNHOOD Power Station batteries.
The
discharging
temperature
of
Energy
Bar
324
is
-68~113°F/-20~45°C, while
the
charging temperature
is
32~104°F/0~40°C. Failure to do so may result in hazard, permanent damage, or reduced performance.
This product is recommended to be used at 68~77℉/20~25℃, otherwise, the higher the temperature, the
shorter the working time may be.
Using the batteries in a strong electrostatic or electromagnetic environment may cause the battery control board
to malfunction and cause serious hazard during use.
If the product is submerged in water during use, remove the product immediately and leave it in a safe and open area. Keep
a safe distance until it is completely dry and dispose of it as described in the Battery Disposal section below. All components
and modules of the power station previously submerged in water should not be used again under any circumstance.
If the product catches fire, it is recommended to use fire extinguishing equipment in the following order: water,
sand, fire blanket, dry powder, carbon dioxide fire extinguisher.
DO NOT insert pins, wires, or other metals into the device case, outlets, or controls. Doing this may short circuit
the product.
Avoid collision.
Summary of Contents for HE600-B
Page 1: ...230V 50Hz...
