Runco DTV-992 ULTRA, Owner'S Operating Manual

Page: 19 / 69

4-3
Controlling
Input selection.
Two possible ways of selecting an input :
a) Display General access menu with RCU by pressing ADJ but-
ton. This brings up a secondary general access menu. Choose
source selection and highlight desired source.
b) With the local keypad :
Press first the
ADJUST key to display the General access menu.
Use the control disk to highlight the desired source number.
Choose from table above. Push the control disk up or down to
move the cursor up and down, push the control disk to the left or
to the right to move the cursor to the left and to the right.
Press
ENTER to confirm your selection.
When a valid and available source is selected, there will be infor-
mation displayed on the screen about that source. This informa-
tion includes :
- Source number
- Horizontal frequency
- Vertical frequency
When the entry is a non valid source number, a warning appears
on the screen : ‘input not available’.
When a valid source number is selected, the projector will display
this source or it will wait on the selected source number until the
source becomes available. A message ‘source not available’ will
be displayed for a short time.
GENERAL ACCESS MENU ITEMS
SOURCE Projector input
1 Comp. Video
2 S - Video
3 RGBS of RGsB
4 RGB3S or RG3sB
5 (R - Y) Y (B - Y)3S or
(R - Y)Ys(B - Y)
6 (R - Y) Y (B - Y)3S or
(R - Y)Y3s(B - Y)
GENERAL ACCESS
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
5 6
3 4
1 2
Enter ADJUST
Select with ,
or
then <ENTER>.
<EXIT> to return
General Access From Local Keypad
GENERAL ACCESS
SELECT AN OPTION
FROM BELOW:
SOURCE SELECTION
EYE-Q
ADJUSTMENT MODE
Select with
or
then <ENTER>
<EXIT> to return
Source 2
Fh = 15.6 kHz
Fv = 50 Hz
Warning
input not
available
Warning
source not
available
GENERAL ACCESS
SELECT AN OPTION
FROM BELOW:
SOURCE SELECTION
EYE-Q
ADJUSTMENT MODE
Select with
or
then <ENTER>
<EXIT> to return
ADJUST
EXIT
STANDBY
ENTER