!
!
To adjust the height of the handlebar, first loosen both
screws on the handlebar (1). Then fully unscrew the
cap screw (2) and pull the handlebar and the two spac
-
er rings in an upward direction. The spacer rings can
be positioned individually above or below the handle-
bar. To fasten, proceed in reverse order.
Please make
sure that you do not lose any parts of the headset
and that the handlebar is mounted in the right di-
rection.
After loosening the saddle clamp, you can pull out the
saddle (observe minimum insertion depth!). Then
retighten (5-8 Nm).
4
5
1
2
5-8 NM
5mm
2
1
5mm
65
m
m
5-8 Nm
!
6
7
8
Only for model LR Light BR.
Turn th
e brake lever
into the correct position and tighten with 2-3 Nm.
The brake on this bike has already been installed
and adjusted by PUKY.
After loosening the saddle clamp, you can pull out the
saddle (observe minimum insertion depth!). Then
retighten (5-8 Nm).
Only for model LR Ride.
When tightening the screw
beneath the bike, the suspension effect of the elasto
-
mer may be slightly reduced (more rigid). This suspen
-
sion becomes more flexible when untightening.
When
adjusting, please make sure that there is no play
between the swing arm and the screw.
5mm
4mm
5-8 NM
2-3 NM
4mm
