Before You Begin
Before you install the AP, verify that all the parts in the packing list are packed and make sure that:
The installation site meets temperature and humidity requirements.
The installation site is equipped with proper power supply.
Network cables are in place.
Precautions
The outdoor AP can be mounted on a wall (thickness: less than 2.5 mm) and a pole (diameter: 80 to 110mm). If the
diameter of the pole is out of the range, the hose clamp is customer-supplied. And the installation site varies with
on-the-spot surveys conducted by technical personnel.
Please make full preparation as described in Chapter 2 and observe the following precautions before you install the AP.
Before connecting the power supply, make sure the external power supply matches the power module inside the AP.
Before connecting the power cord, make sure the power switch is in the OFF position.
When connecting a wire to a binding post, make sure their colors are the same.
Make sure the power supply is properly connected.
Installing the AP
1) Attach the mounting plate to the bottom of the AP and fasten the plate with the supplied M8 x 20mm screws. See
Figure 3-1.
Figure 3-1 Fixing the Mounting Plate to the AP