Ruijie RG-AP180 Series, Hardware Installation And Reference Manual

Page: 16 / 19

·
Hardware Installation and Reference Guide System Debugging
4 System Debugging
4.1 Setting up a Debugging Environment
Use a power adapter or PoE to power the AP.
Setting up the Environment

Verify that the AP is properly connected to the power source.

Connect the AP to a wireless controller through a twisted pair cable.

When the AP is connected to a PC for debugging, verify that the PC and PoE switch are properly grounded.
4.2 Powering Up the AP
4.2.1 Checking before power-up

Verify that the power supply is properly connected.

Verify that the input voltage matches the specification of the AP.
4.2.2 Checking after power-up (recommended)
After powering up, it is recommended that you check the following to ensure normal operation of the AP.

Check if any message is displayed on the Web-based configuration interface for the wireless controller.

Check if the LED works normally.
4.3 Reset/Restore Default Settings
The reset button is hidden in a hole and used by technical support personnel. To avoid abnormal operation, do not use
this button without consultation with technical support personnel.
4.3.1 System Reset
Remove the cover. Insert an iron stick, 1mm or less in diameter, into the hole, and slightly press it. After hearing a click,
keep the stick in the same position for 2s. The system reset is complete.
4.3.2 Restore Default Settings
Remove the cover. Insert an iron stick, 1mm or less in diameter, into the hole, and slightly press it. After hearing a click,
keep the stick in the same position for 3s. Default settings are restored.