Hardware Installation and Reference Guide Troubles hooting
26
6.2.2
Ethernet port is not working after the Ethernet cable is plugged in
Verify that the device at the other end of the Ethernet cable is working properly. And then verify that the Ethernet
cable is capable of providing the required data rate and is properly connected.
6.2.3
Wireless client cannot find the AP
(1) Verify that the device is properly powered.
(2) Verify that the Ethernet port is correctly connected.
(3) Verify that the AP is correctly configured.
(4) Move the client device to adjust the distance between the client and the AP.
6.2.4
LED keeps blinking red
The LED stays blinking red for a long time, indicating the Ethernet port is not conn ected. Verify the Ethernet
connection.
6.2.5
LED keeps blinking green
The AP performs initialization after power on. During this period, the LED keeps blinking green and does not turn
solid until the initialization is completed.
Note
: If the blinking persists for an hour, it indicates the device initialization
fails and the device is faulty.
6.2.6
LED keeps blinking orange (Fit AP mode)
Sometimes the AP performs firmware upgrade after power on. During this period, the LED keeps blinking orange
and does not turn solid until the upgrade is completed.
Note
: Do not plug or unplug the power cord when the Status
LED is blinking as firmware update takes time. If the blinking persists for ten minutes, it indicates the device fails
to complete firmware upgrade and is faulty.
6.2.7
LED does not turn solid blue or blinking blue
After the system starts and the LED does not turn solid blue or blinking blue, probably because the AP has not
established a proper CAPWAP connection with the AC. Verify the AC is operational and configured properly.
