RS900 Family Installation Guide
2.3 RS232 Console Port Wiring
The RS232 port is used for configuring the unit. A straight-through serial cable with a DB-9
connector is required. There is no need to crossover the Transmit and Receive signals from the PC
side since this has been done internally.
Figure 8 - RS232 Female DCE pin-out
Pin
Signal
1 No
Connection
2 Transmit
Data
3 Receive
Data
4 No
Connection
5 Ground
6 No
Connection
7 No
Connection
8 No
Connection
9 No
Connection
Table 2 - RS232 Female DCE pin-out
NOTE: This port is not intended to be a permanent connection and the cable shall be less than 2m
(6.5 ft) in length.
Page 20 of 42
©
2008 RuggedCom Inc. All rights reserved.
Rev100
