9
Winch Assembly and Mounting for 2.0 Model
Step 1 - Mount the Winch
Consult your ATV/UTV manufacturers owner’s manual for all specific winch
related recommendations, instructions and warnings before installation.
To secure the winch, always use:
•
A flat, secure mounting location at least 4.8 mm (3/16 in.) Thick.
•
Lock washers.
•
Hex head cap screws when using a one-piece winch mount plate.
Note:
When using separate winch mount and fairlead plates use hex
head cap screws on the motor side of the base as shown in Figure 2.
•
Torque the mounting bolts to 16 N-m (12 lb-ft)
•
Attach the clevis hook to the wire rope.
»
Put clutch in freespool position.
»
Manually feed cable loop through fairlead.
»
Attach hook to cable loop and re-engage clutch.
Batteries contain gases which are flammable and explosive. Wear
eye protection during installation and remove all jewelry. Do not
lean over battery while making connections.
To install the control box:
•
Mount the control box on winch.
•
Connect the short red cable to the “+” terminal of the motor.
•
Connect the short black cable to the “-” terminal of the motor.
•
Connect the long red cable to the “+” terminal of the battery.
•
Connect the long black cable to the “-” terminal of the battery.
Step 2 - Mount the Control Box
