Step One:
Align the top with the two snaps at
the front of the vehicle. Drape the top over the
vehicle. Open the hook & loop flaps over the
door and snap the front snaps into place. Center
the plastic strip and slip only the plastic part into
the channel at the top of the windshield.
Snap to vehicle
Slip plastic strip into retainer
Open flaps
Step Two:
Lay the
top over the rear bow.
Slide the front edges of
the side panels into the
channel on the rear of
the sport bar.
Slide front edge of the side
panel into the channel
Step Three (Optional):
If the Studs are missing
from the top bow, install Body Studs (not included).
Center the rear seam on the bow and use the snap
flap as a guide for marking the location of each
snap. Center punch and drill a 3/32” hole for each
stud. Install the studs with a sheet metal screw.
Rear bow
Stud locations
(as viewed from interior)
Step Four (Optional):
If the Tension
Straps are missing from the vehicle, install
the included Tension Straps. Center punch
and drill a 7/32” hole in each side of the
tailgate above the existing bolt. Install
each Tension Strap with a Phillips head
screw and a lock nut. Install the Tension
Strap with the hook & loop fasteners
facing the outside of the vehicle.
Tailgate
Center punch and
drill a 7/32” hole
Tension Strap
Use a Phillips head
screw and a lock nut
(as viewed from overhead interior, rear corner)
