RH-5R 5-Watt Radio
USER GUIDE
**NOTE: Your radio was pre-programmed and fully optimized before
shipping to you. You’re not required to use the guide. Go out & play!
Unlike most radios, with the RH-5R you can save a custom frequency
without a computer and software.
Use
[ / ]
to scroll through the pre-programmed channels until
you have reached your desired channel.
To manually lock the keypad press and hold
[LOCK]
on the bottom
left of the face of the radio until it verbally says “Lock”. To Unlock
press and hold
[LOCK]
until radio verbally says “Unlock”.
To turn on Auto Lock press
[F]
,
[1]
,
[4]
,
[F]
followed by either
[ / ]
and
[EXIT]
to leave the menu. This feature locks the radio keypad if
there is no key operation for 5 seconds.
To activate FM Radio listening, press
[FM RADIO]
Use
[ / ]
to tune to desired frequency.
Changing Channels
Manually Entering a Custom Frequency
Keypad Lock/Unlock
FM Radio
Hold
[MONI]
to temporarily change the squelch to zero allowing you to
hear very weak signals.
Monitor a Channel
Signal Strength
Frequency A:
Top displayed frequency.
Example shows numeric frequency (VFO Mode)
Frequency B:
Bottom displayed frequency.
Example shows alpha channel name (MR Mode)
Keypad Lock
Battery Life
Start in VFO mode (press the
[EXIT]
button if not already in VFO
mode)
Then, type in the desired frequency (MHz) using the numbered
keypad. You may need to use
[ / ]
for fine tuning adjustments.
Immediately after entering in your desired frequency, press
[F]
,
[EXIT]
.
Then select the channel you would like to save it to using the
[ / ]
. Save it to a channel that is not already in use.
When finished selecting the channel press
[EXIT]
To turn on the second channel display press
[F]
,
[0]
,
[6]
,
[F]
. Then
press
[ ]
to turn on. Press
[F]
to save and
[EXIT]
to leave the menu.
To alternate between the top and bottom channels, press
[A/B]
.
Rugged Radios | www.ruggedradios.com | 888-541-7223
The RH-5R can switch between Memory (MR) mode
[pre-programmed channels], or Manual (VFO) mode [manually
entered frequencies] by pressing the
[EXIT]
button on the bottom
right of the radio.
• Pre-programmed channels are easily identified by a small
channel number and channel name (also known as an alpha tag).
Switching Modes: Memory/Manual
Out of the box, the RH-5R displays a single channel but has the
capability to display two channels. This is useful if you continuously
switch between channels or need to monitor 2 channels at once.
Dual Display
On/Off/Volume Knob
[CALL]
Push-To-Talk
Menu
[MONI]
Accessory
Port
[EXIT]
[FM RADIO]
LED Display
Up/Down Select
[A/B]
[LOCK]
[ / ]
P.N.
RH5R-V2*
*This guide pertains to RH-5R radios without the flashlight between the antenna and volume knob. For radios with the flashlight, please refer to the Quick Start Guide
for P.N. RH5R-U/V. If your radio does not match these instructions then you need a firmware update. Please call our tech department at 888-541-7223.
Dual Display Shown
To Save It For Later Use
***
The channel names in MR mode are not related to the
frequencies in VFO mode.
