14
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware first in this step. Wrench tighten ALL hardware at the end of
STEP 1F. Some components may be pre-assembled. Nylon lock nuts will not fully screw
onto bolts, they must be wrench tightened to fully go on.
1A.
Attach Base Frame
(A)
to the Rack
(K)
using:
(#1) M12x105mm Hex Head Bolt, QTY 2
(#11) M12 Regular Flat Washer, QTY 4
(#14) M12 Nylon Lock Nut, QTY 2
1B.
Attach Chrome Upright
(C)
to Base Frame
(A)
using:
(#8) M10x25mm Button Head Cap Screw, QTY 4
(#10) M10 Regular Flat Washer, QTY 8
(#13) M10 Nylon Lock Nut, QTY 4
1C.
Insert Sliding Carriage
(D)
onto Chrome Upright
(C)
1D.
Attach Steel Brackets
(F)
to Chrome Upright
(C)
using:
(#3) M16x90mm Hex Head Bolt, QTY 2
(#9) M16 Regular Flat Washer, QTY 4
(#12) M16 Nylon Lock Nut, QTY 2
1E.
Attach Top Frame
(E)
to Steel Brackets
(F)
using:
(#2) M16x110mm Hex Head Bolt, QTY 2
(#9) M16 Regular Flat Washer, QTY 4
(#12) M16 Nylon Lock Nut, QTY 2
1F.
Attach Top Frame
(E)
to the Rack
(K)
using:
(#8) M10x25mm Button Head Cap Screw, QTY 4
(#10) M10 Regular Flat Washer, QTY 8
(#13) M10 Nylon Lock Nut, QTY 4
(B) Mounting Bracket, QTY 1
NOTE: Make sure the Top Frame (E) is centered on the Pull Up Bar of the
Rack (K) before tightenning all the bolts.
Summary of Contents for Y230
Page 15: ...S T E P 1 Above shows Step 1 assembled and completed 15...
Page 17: ...S T E P 2 Above shows Step 2 assembled and completed 17 Note 1 Note 2...
Page 19: ...S T E P 3 Above shows Step 3 assembled and completed 19...
Page 20: ...45 20 N o t e s...
