14
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware first in this step. Wrench tighten ALL hardware at the end of
STEP 1G. Some components may be pre-assembled. Nylon lock nuts will not fully screw
onto bolts, they must be wrench tightened to fully go on.
1A.
Attach Side Base Frames
(B)
to Center Base Frame
(A)
using:
(#1) M16x120mm Hex Head Bolt, QTY 2
(#9) M16 Regular Flat Washer, QTY 4
(#12) M16 Nylon Lock Nut, QTY 2
1B.
Attach Side Base Frames
(B)
to the Rack
(K)
using:
(#2) M16x110mm Hex Head Bolt, QTY 4
(#9) M16 Regular Flat Washer, QTY 8
(#12) M16 Nylon Lock Nut, QTY 4
NOTE 1:
Please refer to the drawing for the correct bolt hole locations. The bolt holes
are the 2nd and 5th holes from the rear end of the Base Frame.
1C.
Attach Chrome Upright
(C)
to Center Base Frame
(A)
using:
(#8) M10x25mm Button Head Cap Screw, QTY 4
(#10) M10 Regular Flat Washer, QTY 8
(#13) M10 Nylon Lock Nut, QTY 4
1D.
Insert Sliding Carriage
(D)
onto Chrome Upright
(C)
1E.
Attach Steel Brackets
(F)
to Chrome Upright
(C)
using:
(#3) M16x90mm Hex Head Bolt, QTY 2
(#9) M16 Regular Flat Washer, QTY 4
(#12) M16 Nylon Lock Nut, QTY 2
1F.
Attach Top Frame
(E)
to Steel Brackets
(F)
using:
(#2) M16x110mm Hex Head Bolt, QTY 2
(#9) M16 Regular Flat Washer, QTY 4
(#12) M16 Nylon Lock Nut, QTY 2
1G.
Attach Top Frame
(E)
to the Rack
(K)
using:
(#3) M16x90mm Hex Head Bolt, QTY 2
(#9) M16 Regular Flat Washer, QTY 4
(#12) M16 Nylon Lock Nut, QTY 2
Summary of Contents for Y210
Page 15: ...S T E P 1 Above shows Step 1 assembled and completed 15 Note 1 Hole 2 Hole 5 Front of Rack...
Page 17: ...S T E P 2 Above shows Step 2 assembled and completed 17 Note 1 Note 2...
Page 19: ...S T E P 3 Above shows Step 3 assembled and completed 19...
Page 20: ...45 20 N o t e s...