48
Picture 10
-8.1-1
10.8. Installation
10. 8.1 Wall mount
On the installation wall, use wall bracket as a templet
to mark the center position of the hole (as picture 10-8.1-1
shows).
User use the electric drill to drill four M6 holes on the
installation surface. The length is around 75mm and then
install M6 screw.
Please see NO.
①
in the picture, smear the sealed glue
on the brim of the bracket and the dome will be prevented
the water entering. (as picture 10-8.1-3):
(1) All sides interface between wall mount bracket
and the wall.
The user must install the outdoor bracket
according to below requirement strictly.
It does not belong to our maintenance
scope if the dome was damaged causing
by disobey the requirement to install.
NOTICE
NOTICE
1. The installation site must be able to support
the sum of weight such as the dome
、
the bracket
and the pedestal four times.
. The chosen wall of installation site must be
solid and have no delaminated phenomenon,
must make sure the bracket installs on the wall
but not in the superficial slipcover.
2
Picture 10
-8.1-3
Picture 10
-8.1-2
242
Φ
60
200
140
170
114
4-
8.
00
Φ
Using the 4pcs M6*12 screws to lock the PTZ and the
wall bracket together
，
then fix them on the wall.As
shown in figure 10-8.1-2
Outdoor dome
Outdoor wall
mount bracket
Installation Introduction
