Ruckus Wireless ZoneFlex R510, Quick Start Manual, Page: 3 / 4

Copyright © 2016 Ruckus Wireless, Inc.
Page 3 of 4
Published January 2016, Part Number 800-70940-001 Rev D
Mounting on a Recessed Drop-Ceiling T-Bar
The enclosed T-bar bracket supports mounting to recessed
drop ceiling T-bars.
•
Mounting an AP using the External Bracket
•
Removing an External Bracket from a T-Bar
•
Removing the External Bracket from the AP
Mounting an AP using the External Bracket
1 Position the studs on the bottom of the T-bar bracket (B
in
Figure 4 ) in the mounting holes on the R510 enclosure,
and then slide the T-bar bracket until the studs are in the
narrow parts of the R510 mounting keyholes.The mount-
ing bracket locks in place on the AP enclosure.
Figure 4. Attaching the external bracket to the AP
2 Attach the locking tab (C in Figure 4 ) to one side of the T-
bar and the bracket (B in Figure 4 ) to the other side of
the T-bar.
3 Slide the locking tab (C) into the bracket (B) so that it
locks in place around the T-bar (
Figure 5 ). Make sure that
both clasps are gripping the T-bar.
Figure 5. Attaching the external bracket to the T-bar
Removing an External Bracket from a T-Bar
1 Move the ceiling tiles out of the way.
2
Slide the locking tab away from the T-bar to release
the AP-bracket assembly from the T-bar.
3
The R510-and-T-bar bracket assembly comes away
from the T-bar.
Figure 6. Removing the external bracket from the T-bar
Removing the External Bracket from the AP
1
Insert the unit removal pin into the hole on the front
of the AP to unlock the mounting bracket from the AP
enclosure.
2 Slide the mounting bracket ( Figure 7 ) toward the
Ethernet ports on the R510 until it detaches from the
R510.
Figure 7. Removing the external bracket from an AP
Mounting on a Flush Drop-Ceiling T-Bar
Mounting an AP using the Integrated T-bar clips
1
Orient the AP so that the T-bar is positioned between
the T-bar clips as shown in
Figure 8
, then rotate the AP
until the third T-bar clip catches the T-bar and the
latch locks the T-bar in place (
Figure 9
).
Figure 8. Attaching the AP to the T-bar
Figure 9. Locking the AP to the T-bar
2
Insert the Torx security screw into the hole near the
latch to lock the AP in place.
Removing an AP Integrated Bracket from a T-Bar
1 To remove the AP from a T-bar, first remove the
security screw, then depress the latch while rotating
the AP so that the T-bar clips disengage the T-bar.
Mounting on a Truss or Pole
1
Feed the customer-supplied cable ties through the
four slots on the back of the R510.
Figure 10Cable tie slots
2
Fasten the R510 to the truss or pole using the cable
ties.
Note: This mounting bracket can also be used on a flush
drop-ceiling T-bar, so the four rubber feet on the bottom
of the AP minimize ceiling tile displacement.
Note: The built-in mounting clips on the bottom of the AP
are designed to accommodate 15/16 T-bar widths only.