Ruckus Wireless ZoneDirector 3000, User Manual, Page: 58 / 430

Changing the Network Addressing
IPv6 Configuration
58
Ruckus Wireless, Inc.
Figure 23. The Device IP options
3 Select one of the following:
• Enable IPv6 Support: By default, ZoneDirector operates in IPv4 mode. If your
network uses IPv6, select
Enable IPv6 Support and enter configuration
settings for either IPv6 only or dual IPv4/IPv6 support. See IPv6 Configuration
below for more information.
• Manual : If you select Manual, enter the correct information in the now-active
fields (IP Address, Netmask, and Gateway are required).
• DHCP : If you select DHCP, no further information is required.
4 Click
Apply
to save your settings. You will lose connection to ZoneDirector.
5 To log back into the web interface, use the newly assigned IP address in your
web browser or use the UPnP application to rediscover ZoneDirector.
IPv6 Configuration
ZoneDirector supports IPv6 and dual IPv4/IPv6 operation modes. If both IPv4 and
IPv6 are used, ZoneDirector will keep both IP addresses. Ruckus ZoneFlex APs
operate in dual IPv4/v6 mode by default, so you do not need to manually set the
mode for each AP.