Installing the T504
Deploying the T504
T504 Strand Mount Concurrent AP with Integrated CM Installation Guide, 800-70610-001 Rev A
23
2
Insert the F-type coaxial cable that is connected to the HFC cable plant to the
F-type connector on the T504. Power is supplied through a power passing tap
on the CATV coax. The tap is connected to F-type connector on the T504 as
shown in
3
Finger tighten the coaxial cable connector and then tighten to 3.4 N.m (30 in-lbs).
4
Plug the power jumper back into the power tap to restore AC power out of the
power tap.
5
When the T504 receives power, its LEDs flash on and off as it goes through a
power-on self test and then receives its AP and CM configurations from the cable
operator.
NOTE
Normally, the T504 receives its AP and CM configurations from the cable
operator. This means that the installer does not need to manually configure either
the AP or the CM part of the T504.
6
Wait until the T504
PWR, CM DS, CM US,
and
ONLINE
LEDs stop flashing and
then remain on.
You have verified that the T504 is powered. Continue with
with an RF Power Meter (Optional)
.
DRAFT
