1GLAL
1GLAC
1GLAR
Loosen the lock nut using
* 17mm
Deep Socket.
1/2“ Drive
LOCK NUT
Recommended
torque 20Nm
1
2
5
6
HANDLE ALIGNMENT (1G)
3
4
Use Handles to
unscrew cartridge.
Turn both splines
counter clock-wise.
Once cartridge valves are loose, screw them
back into the faucet using the handle.
Stop when you feel a noticeable resistance.
Then remove handles.
Replace Left Handle (hot)
one tooth off
from the
OFF
position as shown.
And Right Handle (cold)
one tooth off
from the
ON
position as shown.
Turn the handles to the desired alignment.
(This will unscrew the cartridge)
This adjustment should not be more than 25
º.
Tighten Lock Nut using
17mm
Deep Socket.
wrench to secure cartridge valve position.
*Use handle to hold spline while tightening.
Remove
THREADED
SLEEVE
LOCK NUT
6
WALL MOUNT LAVATORY SET
ASSEMBLY INSTRUCTION
1GLAL - C - R
REMOVAL OF FAUCET:
Always turn the water supply off before removing the existing faucet or disassembling a valve. Open both faucet handles to relieve water pressure
and to ensure that the water has been successfully turned off.
CARE OF FAUCET:
The use of warm water and a soft cloth is all that is required to clean Rubinet products. The patina of our living finishes (Oil Rubbed Bronze &
Tuscan Brass) will change as a result of normal use. Applying Mineral Oil on occasion will create a softer look, subtle color changes and character.
CONTACT US:
If you need assistance with installation, replacement parts or have any questions regarding your Rubinet product,
please call a Customer Service representative at:
905-851-6781
toll free
1-800-461-5901
or visit
www.rubinet.com
210301
