Programming kit - RTX4002 Repeater
1. Auto registration
1. Ensure that the repeater is switched off
.
Disconnect the power plug.
2
.
Set the base station in registration mode.
On most base stations, holding down the “Registration or Page” key for several seconds starts the procedure. Consult
your base station user guide for more information.
3. Switch on the Repeater
Connect the power plug.
4. The LED on the Repeater flashes.
After a short while the LED stays on permanently indicating that registration is complete and the unit is ready for
operation.
2. Manual registration
1. Set the repeater in registration mode
Insert the repeaters power plug for 1-5 seconds in the socket and then remove it. Insert it once more and leave it there.
The LED on the repeater flashes slowly after the start. You now have five minutes to carry out the registration. If the
procedure is not carried out within this period you must start over again.
2. Set the base station in registration mode
On most base stations, holding down the “Registration or Page” key for several seconds starts the procedure. Consult
your base station user guide for more information.
3. The LED on the front of the repeater flashes
If the LED flashes very quickly without interruptions go to step 5. If the LED flashes very quickly with brief
interruptions go to step 4.
4. Registration of the handset
If the base code has been changed, it must be set to “0000”. You must repeat the registration procedure even if the
mobile unit used was already registered at the base station, (consult your base station user guide for more
information). Now the LED flashes very quickly without interruptions.
5. Assign a repeater number
You must now assign a repeater number to the repeater (selection: 2-7, for up to 6 repeaters). Please note that each
number only can be assigned once, when using more than one repeater. These numbers are independent of the mobile
unit extension numbers.
Hook off by pressing the
-key (the LED stops flashing). Press a number between 2 and 7. When the repeater has
accepted the chosen number, the LED will flash a corresponding number of times. Accept the registration by pressing
the
*
-key and then the
-key (hook on). The repeater is now automatically restarted. The LED goes off for 2 seconds,
flashes for a brief moment and the remains continuously illuminated. The registration of the repeater is completed.
You can now disconnect the power and move the repeater to the selected location (disconnecting the power will not
delete the registration.)
3. Reset the repeater
1.
Switch off the repeater.
Disconnect the power plug.
2. Switch on the repeater for 1 to 5 seconds and switch off again.
3. Switch on the repeater for 25 to 35 seconds on switch off again.
Now the repeater is ready for a new registration.
Note: Reset the repeater will also delete the registrations in the repeater.
