20 Installation
DKP-4016
Bosch Security Systems, Inc.
Technical Manual
F.01U.308.248
Rev. 03
DKP-4016 Installation
IMPORTANT:
For DKP-4016W wall mounting instructions, see “Wall Mounting Option” on page 275.
To
install the DKP-4016
, do the following:
1.
On the rear panel of the DKP-4016, plug the
AC power cord (A)
into the power connector on the back panel of the
unit.
2.
Connect an
RJ-12
or
RJ-45 (USOC or 568B) cable
(B)
with RTS cabling to the J8 FRAME connector.
OR
Connect an
CAT-5e cable (C)
to either J11 or J12 ETHERNET connector.
NOTE:
•
If you have the option J13 fiber connector installed, connect a
fiber connector (D)
to the OPTICAL
fiber connector on the rear panel.
•
The KP-Series panels can have both AIO and Ethernet connected simultaneously, and the user can
switch between connections using the menus.
3.
Once the unit is cabled, plug the
AC power cord
into the wall outlet or a power strip.
FIGURE 3.
DKP-4016 Installation
Summary of Contents for DKP-4016
