146 Basic Operation
DKP-4016
Bosch Security Systems, Inc.
Technical Manual
F.01U.308.248 Rev. 03
Input Bandpass Filters Group Box
The
Input Bandpass Filters
group box is used to enable bandpass filters which set a low and high frequency range where
frequencies within the two (2) frequency points are passed and anything outside of the range is rejected.
IMPORTANT:
OMNEO 3 through OMNEO 8 only appear when the Audio Package is purchased, otherwise, they do
not display.
To
configure input bandpass filters
, do the following:
1.
Select the
Enabled column check box
for the input you want to set a bandpass filter.
2.
From the Low Freq column drop down menu, select the
low frequency
you desire.
3.
From the High Freq column drop down menu, select the
high frequency
you desire.
FIGURE 79.
Filters Page – Input Bandpass Filters Group Box
Summary of Contents for DKP-4016
