RTS 3PS Assembly Instructions Download Page 4

 

You will notice that there are two long sides 

(B 1-2

) and two short sides (

C 1-2

) that 

will fit into the base plate (

A

).  

 

PREPARING THE CUT PIECES 

Firstly, remove all the laser cut parts from the sheets. The sheets can be discarded. 
Clean the edges of the parts if there are any tiny bits where the parts were fixed to 
the sheets. This can be done with your knife or even your thumb nail. 

We recommend that you start by sanding your finished product with a very light 
sandpaper to ensure a smooth finish for the end product.  

 

WORD OF ADVICE 

We would strongly advise you to do a quick dry assembly before you start gluing the 
laser cut parts together. Lay out all the parts on your work surface and make sure 
that the parts are not upside down or mirrored. In most instances it will make no 
difference, but in others it may be crucial to ensure a perfect product in the end. 

 

PAINTING YOUR PRODUCT 

We would strongly advise you to finish the product with paint or wood stain to make 
them as appealing as possible. The parts should be primed (2 coats) and painted 
before final assembly. Spray paint can also be used to get a very smooth finish. Oil 
or water-based paint can be used and specialised paints like chalk paint can be used 
to give unique finishes. 

Generally, it is highly advisable to paint/spray before gluing. You may not be able to 
get to the inside of the structure after it is glued together. Covering all the parts that 
must not be painted or sprayed with the same colour can be a tedious process. Pre-
painting will avoid this process. 

Please ensure that no paint clog a sleeve where a lug must fit in later. The 
tolerances are often so tight that too thick a layer of paint may cause problems. It is 
our experiences that a small foam roller instead of a brush, will produce a better 
finish and far less clogging of sleeves. 

Applying a base or undercoat normally makes life easier afterwards. Two coats of 
primer are advisable because the MDF absorbs a lot of paint. Using a single colour 
for the undercoat of all parts works quite well from personal experience. You can 
choose the paint of your preference, whether it is oil or water based. Cleaning 
brushes and rollers are just so much easier if you use a water base paint. A chalk 
paste can give a unique finish to walls and give a weathered look if so desired. If you 
prefer to protect the paint work of your structure you can always apply a clear spray 
coat. 

 

Reviews: