RTRMAX RTH182, Original Instruction Manual

Page: 5 / 27

Проверил: Р.Ч./24.03.2015г

Do not begin to cut, before the machine reaches speed exactly.

Compress the workpiece firmly and never try to cut too small pieces.

Put machine anywhere after only switch is off and the blade is exactly stopped.

After switch off, do not brake the saw blade to a stop by applying side pressure.

Always pull the mains plug.

Do not use circular saw blades which is thicker than separation wedge thickness.

Do not use circular saw blades which has smaller thread width than separation wedge
thickness.

Provide the mill diameter available for saw hole.
ADJUSTING CUTTING DEPTH
Cutting stepless can be adjusted stepless. A clear section is obtained after circular saw leave from
workpiece about 3mm.
Loose the adjusting screw.
o
Adjust cutting depth by measure.
o
Tighten the adjust screws.
ANGLE BALANCING
Cutting angle can be adjusted between 0º and 45º as stepless.
1.
Loosen the adjusting screws.
2.
Adjust desired angle with measure.
3.
Tighten the adjusting screws.
MOUNTING PARALLEL FENCE
It is available for cutting with parallel fence near to 1 edge 10cm distance
Loosen the adjusting screw.
Place the parallel fence to saw sliding ways.
Adjust the paralel fence to desired distance.
Tighten the adjusting screw.
OPERATING
Always use the correct supply voltage.
The voltage of the power source must agree with the value given on the nameplate of the
machine.
Tighten the piece. Provide the machine stand to clear part of workpiece.
Switch on the machine, before connecting to piece. Do not press to circular saw.