Проверил: Р.Ч./14.01.2017г.
Dust extraction prevents large accumulations of dust, high concentrations of dust in the
ambient air and facilitates disposal.
For long periods of working with wood or for commercial use on materials that produce dust
that is detrimental to health, the machine is to be connected to a suitable external dust
extraction device.
PENDULUM ACTION SETTING
The saw blade pendulum action that is adjustable in four steps makes possible the optimum
adaptation of sawing advancin(cutting speed) , cutting performance and cut appearance of the
material to be worked.
For each downward movement, the saw blade is lifted off the material which facilities
sawdust ejection reduces heat generated by friction and increases the service life of the saw
blade. At the same time the reduction of the necessary advancing force makes fatigue-free
working possible. The adjustment lever makes possible the adjustment of the pendulum action
in four steps. The switching can take place with the machine running.
Step 0:
No pendulum action
Step 1:
Small pendulum action
Step 2:
Medium pendulum action
Step 3:
Large pendulum action
The following basic recommendations are to be observed:
The finer and cleaner the cut edge should be, the smaller the pendulum step selected
should be or switch off.
Fort he working of thin metal such as sheet metal, switch off the pendulum action.
In materials such as softwood and cutting in the direction of the grain, the maximum
pendulum action can be used.
OPERATING INFORMATION
CUTTING
Do not depress too much to worpiece for avoiding damaging and heating of blade. For
avoiding vibration and cutting beter, put the workpiece to a firm plate.
CUTTING ANGLE ADJUSTMENT
For cutting of mitre angles loosen the 2 set screws till the saw shoe to the required mitre
angle. Mitre angle to the left/right is maximum 45°. After adjusting desired angle, tighten the
set screws firmly. Adjustable angles on jigsaw are 0°, 15°, 30°, 45°.
PLUNGE SAWING
