Проверил: Р.Ч./24.03.2015г
CORDLESS SCREWDRIVERS
The tool’s bits should be used by the bit holder. Use only those which fit in holder properly.
CHARCING THE BATTERY
Place the tool 1 meter away from the plug in a clean and dry place.
Insert AC adaptor into the charging port located on the back of the unit.
Plug the AC adaptor into the power supply.
Allow 5 to 7 hours for the battery to fully charge.
When the battery has fully charged disconnect the charger from the power supply.
The LED battery level indicator tells you the amount of the charge that you have on the battery.
When all three lights ( ( RED,YELLOW, AND GREEN ) are illuminate, it indicates that the
battery is on full capacity.
When 2 lights ( YELLOW AND RED ) are illuminated, it indicates that the level of the battery
declines.
When only 1 light ( RED ) is illuminated, it indicates that the battery level is low and needs to be
re-charged.
TORQUE ADJUSTMENT
In order to prevent the bits and the rotating part from damages, the tool has a function to adjust
the level of the torque speed. This function is controlled in the upper end of the tool.
OPERATION
1.
Insert the bit into the chuck.
2.
İki eliniz ile aleti sıkıca tutarak ucu yerleştirin.
3.
Start the tool by squeezing the Forward/Reverse trigger switch. Press the top of the switch
to turn the screw FORWARD. Press the bottom of the switch to REVERSE the screw.
4.
To turn the worklight on, slide worklight ON/OFF switch forward to the ON position.
Slide the switch back to the position to turn the light OFF.
MAINTENANCE
1.
Use only soap and rags to clean the tool.
2.
Do not allow any kind of liquids to get inside the tool.
3.
Do not immerse any part of the tool in liquids.
NOTE: Despite of the care taken during the manufacture and test analysis if the tool fails,
please take the tool to the authorized service agent for
RTRMAX
electric tools.
