RTR PREMIUM SF7J112, Instruction Manual

Page: 4 / 21

Проверил: Р.Ч./24.03.2015г
The chain saw should not be used during rain, neither shoold It be left
outside by rainy weather.
Fitting the guide bar and Saw chain
If the chain saw is already connected To the power supply: pull the plug From the socket outlet.
Wear protective gloves whenever doing any work on the saw chain.
15 16
The chain must be so fitted over the guide bar that the cutting edges of the cutters (a) face in the direction
that the chain runs.
Hold the guide bar with the nose upwards and place the saw chain so on Unscrew the nuts(2)
and remove the drive-sprocket cover(lXsee the picture on the front page).
Bring the chain tensioning pin(12)into its extreme left-hand position(when viewing the tool as in
Fig.l)by turning the tensioning screw(9)anticlockwise as far as it will go.
The direction of rotation of the saw chain is indicated by two arrows on the drive-sprocket cover.
the bar that the teeth(b) on the nose sprocket of the guide bar engage in to the chain links and the bottom
sections of the drive links are situated in the groove of the bar.
Then put the saw chain round the drive Sprocket(13) and place the guide bar With its slot so onto the
threaded studs (11)that the chain tensioning pin(12) engages in the hole(15) in the bar.
Replace the drive-sprocket cover(l) and screw on the nots(2)bnt do not yet tighten them.
With the nose of the guide bar turned upwards turn the tensioning screw(12) clockwise to take up
any slack in the saw chain.
The chain is correctly tensioned when it is still
possible to raise it by 3-4 mm In the middle of the
guide bar
Fig 3
After tensioning the saw chain turn the nose of the bar upwards and tighten the nuts (2) firmly.
Lubricating oil for the saw chain
When the chain saw is supplied new, there is no oil in the oil container and so the container
mast be filled with chain-saw oil before starting up.
Use for the first filling the chain-saw oil supplied with the tool This oil is biologically
degradeable. It allows operating the chain saw at Low as -15 *C.
Never use waste oil for lubricating To top the saw up with lubricating oil When switching the
chain saw on, the unscrew the filler cap (3). Make sure hand-protection guard (6) must be in
that no dirt gets into the oil container its normal position, i.e. be pressed in while filling up. The
oil level can be checked through the gauge glass (14).
1312 11