![background image](http://html1.mh-extra.com/html/rti/miravue-vip-1/miravue-vip-1_technical-bulletin_1497688004.webp)
4 |
P a g e
01/2019
RTI | Miravue VIP-1 Manual
INSTALLATION OVERVIEW
1)
VIP-1 Front Panel Ports
IR-REC
Infrared receiver, used for IR control of the VIP-1 via a remote control.
NOTE: This IR receiver is disabled if the IR-IN port is used.
DEFAULT
Button resets the VIP-1 to factory defaults if pressed and held for 10 seconds.
RESET
Button power cycles the VIP-1 if pressed and released.
IR-OUT
•
Port delivers infrared control to an external device (e.g. TV, Satellite Receiver) from an RTI control
system.
•
Connect standard IR emitter to 3.5mm jack.
NOTE: VIP-1 must be configured as an expansion device in the Integration Designer system file.
RS232
•
Port delivers serial communication to an external device (e.g. Projector, Blu-Ray) from an RTI control
system.
•
Connect a three wire cable (Tx, Rx, and GND) between 3.5mm jack and external device.
•
RS-232 Jack Pinout: Tip=Rx In, Ring=Tx Out, Sleeve=GND
NOTE: VIP-1 must be configured as an expansion device in the Integration Designer system file.