CP-450
18
Cool Power
Audio Amplifier
SPEAKER WIRE TERMINATION
Install the two supplied phoenix connectors into the speaker outputs on the
CP-450. Connect the positive and negative wires for each audio channel
output, keeping the proper orientation of positive and negative signal for
each speaker connection. Typically, two-conductor speaker wire uses red to
denote positive and black to denote negative. Some types of wire indicate
positive with a line running through the insulation. Four-conductor wire can
also be used. This has four separated wires in one outer jacket, making
it possible to run a single speaker wire to a zone for its pair of speakers.
This type of wire typically uses red and black for one speaker and white as
positive and green as negative for the second speaker.
IR CONTROL OF CP-450
A discrete set of IR codes is available within the RTI Integration Designer
programming software or on the RTI website (accessible to RTI dealers
only). A 3.5mm mono mini jack labelled IR In is located on the rear of the
CP-450. All IR commands received are looped out through the IR Out jack.
RS-232 CONTROL OF CP-450
A DB-9 jack offers RS-232 control of the CP-450 from an RTI or third-
party home automation control system or a PC running a hyperterminal
program. A set of RS-232 codes is available within the RTI Integration
Designer programming software or on the RTI website (accessible to RTI
dealers only).
Connection Settings:
Baud rate: 9600
Data bits: 8
Parity: None
Stop bits: 1
DB-9 Jack Pinout:
1
DCD
Carrier Detect
2
TXD
Transmit Data
3
RXD
Receive Data
4
DTR
Data Terminal Ready
5 GND Ground
6
DSR
Data Set Ready
7
RTS
Request to Send
8
CTS
Clear to Send
9
N/C
Not Connected
CHAPTER 3 | INSTALLATION AND OPERATION
Summary of Contents for Cool Power CP-450
Page 8: ...CP 450 8 Cool Power Audio Amplifier...
Page 15: ...15 It s Under Control...
Page 22: ...CP 450 22 Cool Power Audio Amplifier...