Use screws F to assemble the sliders (11) to the slider bases (10) as shown. Note that the
screw enter thru the tube and into the slider, not from the slider into the tube.
Assemble the slider bases (10) to the unit using:
- Screws D to assemble it to the horizontal tube (4) from behind the unit;
- Screws A to assemble it to the support tubes (9) from underneath.
Place the keyboard panel over the tabs of the sliders (11) and assemble it from underneath
using screws (G) as shown.
P.8
RTA-3788
P.8
STEP 9
Screws:
F
4x23mm
4
pcs
STEP 11
Screws:
G
4x14mm
4
pcs
Note the correct orientation
of all the parts.
(Front)
STEP 10
Screws:
A
6x35mm
2
pcs
D
6x50mm
2
pcs
DONE! Before you start using the unit, make sure that all the screws, bolts, etc. are properly tightened,
and read all the warnings in the next page.
Note that the tabs on
the sliders face down.
